TANDBERG MPS API Interface D13639 - Manual (Page 60)

TANDBERG MPS API
User Guide
58
*r/end
OK
FloorToSite Command used to assign floor to a specific site in a conference.
Parameters:
•
Conference(r): <1..35>
•
MCUID(r): <1..191> MCUID to the MultiSite the site is connected to.
•
TerminalID(r): <1..191> The site’s terminal id, referenced to the
MultiSite it is connected to.
OK Result parameters:
None
ERROR Result parameters:
•
Cause: <1…> Cause code specifying why the command was not
accepted by the system
•
Description Textual description of the cause code.
Example:
xcommand floortosite conference:4 mcuid:85
terminalid:2
*r Result (status=OK):
*r/end
OK
FloorToSiteEnd Command used to end the assignment of floor to a specific site in a
conference supporting. Requires that the command FloorToSite has been
issued in advance.
Parameters:
•
Conference(r): <1..35>
OK Result parameters:
None
ERROR Result parameters:
•
Cause: <1…> Cause code specifying why the command was not
accepted by the system
•
Description Textual description of the cause code.
Example:
xcommand floortositeend
*r Result (status=OK):
*r/end
OK
GroupEntryAdd Command used to add a new Group entry to the locally stored Group
Directory (or MultiSite Directory). The entry is stored in the first vacant
position in the Group Directory.
Parameters:
•
Name: The entry’s name.
•
LocalEntryId.1..32: <1..99>References to local entry ids to be
included in this Group entry.
OK Result parameters: