TANDBERG MPS API Interface D13639 - Manual (Page 29)

TANDBERG MPS API
User Guide
27
Example 2.12
xcommand Dial ?
*h xCommand Dial
Number(r):
SubAddress:
CallRate: <1xh221/2xh221/64/128/256...
Restrict:
NetProfile: <1..6>
OK
NOTE! Required parameters are identified by an “(r)” behind the parameter name.
2.4.2 Issuing a command
A command must start with a command-type root command, followed by a command name,
followed by a set of parameters. Parameters values can either be specified by a mark-up
notation or by placing the parameter values in the sequence specified by the help text – or a
combination of these methods.
Markup notation
...
When using this notation, the sequence the parameters are entered is unessential:
Example 2.13
xcommand dial number:666 restrict:on callrate:128 subaddress:10
Abbreviations can be used for the parameter names as long as the parameter names are
unique within the command:
Example 2.14
xcommand dial nu:666 r:on c:128 s:10
If there are multiple instances of a parameter, the item number is added after the tag separated
with a dot:
...
Example 2.15
xcommand groupentryadd name:TANDBERG localentryid.1:15
localentryid.2:57