TANDBERG MPS API Interface D13639 - Manual (Page 50)

TANDBERG MPS API
User Guide
48
4.1 command.xml – xcommand
Boot Command used to reboot the system.
Parameters:
None
OK Result parameters:
None
ERROR Result parameters:
•
Cause: <1…> Cause code specifying why the command was not
accepted by the system
•
Description Textual description of the cause code.
Example:
xcommand boot
*r Result (status=OK):
*r/end
OK
CallFURBlock Command used to block Fast updates to a call
Parameters:
•
Call(r): <1..176>
•
Value(r):
OK Result parameters:
None
ERROR Result parameters:
•
Cause: <1…> Cause code specifying why the command was not
accepted by the system
•
Description Textual description of the cause code.
CallMoveToQCIF
Command used to move a call to QCIF
Parameters:
•
Call(r): <1..108>
OK Result parameters:
None
ERROR Result parameters:
•
Cause: <1…> Cause code specifying why the command was not
accepted by the system
•
Description Textual description of the cause code.
CallMute Command used to mute incoming audio from a specific call.
Parameters:
•
Call(r): <1..128> Reference to the call to be muted or unmuted.
•
Mode(r): Denotes whether the call is to be muted or
unmuted.
OK Result parameters:
None
ERROR Result parameters: