Teledyne 4220 - Manual (Page 49)

4220 Flow Meter
Section 2 Programming
2-21
If you select any of these outputs, the flow meter will request
that you turn them on or off. If you are running on battery and do
not intend to use either of these options, select OFF. Otherwise,
select ON. After the OPTIONAL OUTPUTS menus have been
set, press Enter. The display will return to the SETUP menu.
This time, select REPORT SETUP with the arrow key. Press
Enter.
This step lets you determine the contents of the reports gen-
erated by the flow meter. The flow meter's report generator is
capable of creating two different reports (A and B) that can be
identical or quite different. The reason for two reports is to allow
the summary of flow meter recording over different time periods.
For example you might generate report A weekly, and report B
monthly. At this point we are only interested in selecting the
items the flow meter will include in each report. Press Enter and
the following will appear:
FLOW METER HISTORY is just off the screen, to the right. If
you select FLOW and press Enter, the following will appear:
Select YES if you want LEVEL to appear in the report, then
press Enter. The following will appear:
Select YES if you want FLOW RATE to appear in the report,
then press Enter again. Then:
Select YES if you want RAINFALL to appear in the report. Note
that you must have a rain gauge connected to the flow meter to
sense rainfall occurrence. Press Enter. The following will
appear:
FLOW METER HISTORY is off the screen to the right. Select
DO/PH. Press Enter. The following will appear:
REPORT SETUP
• REPORT A • • REPORT B •
REPORT SETUP
• FLOW • • DO/PH • •YSI 600 • • SAMPLE HISTORY •
LEVEL IN REPORT
• YES • • NO •
FLOW RATE IN REPORT
• YES • • NO •
RAINFALL IN REPORT
• YES • • NO •
REPORT SETUP
• FLOW • • DO/PH • • YSI 600 • • SAMPLE HISTORY •
PH OR DO IN REPORT
• YES • • NO •