Toshiba PCS-1 - Manual (Page 155)

PCS -1/1P
3-207-456-12 (1)
I:\3207456121PCS1WW\09OTH.FM masterpage:Left
155
Location and Function of Parts and Controls
Ap
pe
ndi
x
Location and
Function of Parts
and Controls
Front/Right side
a ON LINE indicator
Blinks during dialing or answering and
lights in blue when connection is
completed. It turns off when the system
is disconnected.
b POWER indicator
Lights in green when the power switch is
set to on (@). Lights in orange when the
Communication Terminal is set to
standby mode.
c LAN ALERT indicator
Lights in yellow when packet error
(loss) or link error occurs during
communication.
d Memory Stick slot
Insert a “Memory Stick” (not supplied)
into this slot.
e Power switch
Turns on/off the Communication
Terminal. The power is on when the
switch is set to the @ side and off when
the switch is set to the a side.
f AUX CONTROL connector (D-sub
9-pin)
Used for service.
Rear
a AUDIO OUT (MIXED) jack (phono
jack)
Used when recording the sound to
minute a conference. The mixed sounds
of a local and remote parties are output
from this jack.
b AUDIO OUT jack (phono jack)
Connect to the audio input of the TV
monitor.
c VIDEO IN AUX 1 connector (mini
DIN 4-pin)
Connect to the video output of external
video equipment.
d VIDEO IN AUX 2 jack (phono jack)
Connect to the video output of external
video equipment.
e AUDIO IN jack (phono jack)
Connect to the audio output of the
optional VCR or audio equipment.
f CAMERA UNIT connector
Connect to the TERMINAL connector
on the rear of the Camera.
Appendix
PCS-P1/P1P Communication
Terminal
ON LINE POWER LAN ALERT
1 2 3 4
5 6
DC 19.5V
AUDIO OUT AUDIO IN AUX1– VIDEO IN –AUX2 CAMERA UNIT MIC (PLUG IN POWER) ISDN UNIT WHITE BOARD
(MIXED)
AUX MAIN– MONITOR– SUB VIDEO OUT RGB OUT DSB
IR OUT
100BASE-TX 10BASE-T
1 2
1 2
1
q; qa qs qd qf qg qh qj qk
2 3 6 7 8 9 5 4