Toshiba PCS-1 - Manual (Page 142)

142
Starting a Multipoint Videoconference
PCS -1/1P
3-207-456-12 (1)
I:\3207456121PCS1WW\08OPE.FM masterpage:Left
The system begins dialing the numbers selected in step 3. “ Dialing (LAN)”
or “ Dialing (ISDN)” appears on the monitor screen, and the ON LINE
indicator (blue) on the Communication Terminal blinks.
When the system connects to all the remote parties, the message “Meeting
starts!” appears on the screen, and the ON LINE indicator stops blinking and
lights.
To call the second and other remote parties
After starting communication with the remote party selected first, press the
CONNECT/DISCONNECT (
/ ) button on the Remote Commander to
open the submenu.
Perform steps 1-4 of the procedure shown in “To call remote parties by
selecting from the Phone Book” on page 139 or steps 1-4 of the procedure in
“To call remote parties not registered in the Phone Book” on page 141
depending on the registration status of each remote party.
If some points are not connected
The following dialog appears. Select the desired item.
Start Meeting: Starts a conference with remote parties connected.
Disconnect All: Cancels all the connections and restores the launcher menu.
Redial: Redials the numbers of the points that you failed to connect.
Operations are the same as those for a point-to-point conference.
For details, see “Receiving a Call from a Remote Party” on page 68.
Receiving a Call from a Remote Party
Cancel
Phone Book
Dial
Disconnect
Some Positions were not connected.
Status
XX YY Cause Code
Redial Disconnect All
Start Meeting
A B C D E