Toshiba 52HMX95 - Manual (Page 91)

91
Chapter 8: Using the TV’s features
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 52/62HMX95
Adjusting the audio
(continued)
Adjusting the audio quality
You can adjust the audio quality by adjusting the bass, treble,
and balance.
To adjust the audio quality:
1. Press MENU and open the
Audio menu.
2. Highlight Audio Settings
and press ENTER.
3. Press zor y to highlight
the item you want to adjust
(bass, treble, or balance).
Done
Audio Settings
Bass 100
Treble
Reset
100
0
85
Balance
SBS
SBS Level
StableSound Off
On
4. Press x or • to adjust the level.
• x makes the bass or treble weaker or increases the balance
in the left channel (depending on the item selected).
• • makes the bass or treble stronger or increases the balance
in the right channel (depending on the item selected).
5. To save the new settings, highlight Done and press
ENTER. To reset the settings to the factory defaults,
highlight Reset and press ENTER.
Using the sub-bass system (SBS)
The sub-bass system allows you to enhance bass performance,
even when the volume is low.
To turn on the SBS and adjust the level:
1. Press MENU and open the Audio menu.
2. Highlight Audio settings and press ENTER.
3. In the SBS field, select On.
4. Press
y or z to highlight SBS Level, and then press x or •
to adjust the sub-bass system.
Done
Audio Settings
Bass 100
Treble
Reset
100
0
85
Balance
SBS
SBS Level
StableSound Off
On
5. To save the new settings, highlight Done and press
ENTER. To reset the settings to the factory defaults,
highlight Reset and press ENTER.
To turn off the SBS:
Select Off in step 3.
Using the StableSound ® feature
The StableSound ® feature limits the highest volume level to
prevent extreme changes in volume when the signal source
changes (for example, to prevent the sudden increase in volume
that often happens when a TV program switches to a
commercial).
To turn on the StableSound
® feature:
1. Press MENU and open the Audio menu.
2. Highlight Audio Settings and press ENTER.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
Navigate Select Back Exit CH RTN EXIT
3. In the StableSound field, select On.
Done
Audio Settings
Bass 100
Treble
Reset
100
0
85
Balance
SBS
SBS Level
StableSound On
On
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Note: The RESET function returns your audio adjustments to
the following factory settings:
Bass ............. center (50)
Treble .......... center (50)
Balance ........ center (0)
StableSound ... Off
To turn off the StableSound feature:
Select Off in step 3 above.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
Navigate Select Back Exit CH RTN EXIT