Toshiba 52HMX95 - Manual (Page 57)

57 Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 52/62HMX95
Chapter 6: Setting up your TV
To view the system status:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. A new set of
Installation menu icons will appear on-screen, as shown
below right.
Navigate Select Back Exit CH RTN EXIT
Installation
Sleep Timer
On/Off Timer
Setup
PC Settings
HDMI 1 Audio Auto
Auto
2 Sec
HDMI 2 Audio
Slide Show Interval
Navigate Select Back Exit CH RTN EXIT
System Infomation
System Status
3. Open the System Status menu, highlight System
Information, and then press ENTER.
4. Press x • to scroll through the menu bar to check the
Product Information and Software Version.
System Information
Done
Brand:
Model:
IEEE1394 GUID:
Toshiba
52HMX95
00003914-28343803
Product Information
System Information
Done
0.3.0
Mar 9 2005 - 12:37:10
FW:0.12
Sub:47
Software Version
To close the screen and return to the Installation menu:
Highlight Done and press ENTER.
To return to normal viewing:
Press EXIT.
Restore Factory Defaults
To restore all settings and channels to their factory default
values:
1. Follow steps 1–3 above.
2. Press
x • to scroll through the menu bar to select Factory
Defaults.
3. Enter your PIN code (or 0000 if no PIN code has been set).
4. Highlight Yes and press ENTER. The TV will turn off
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the restore process.
System Information
Press YES to confirm. After the TV
turns off, unplug it and plug it dack
in to complete the reset.
Yes No
To cancel the reset:
Highlight No and press ENTER.
Viewing the system status Viewing the digital signal meter
You can view the digital signal meter for the ANT 1 and ANT 2
digital TV input sources only.
To view the digital signal meter:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER.
Navigate Select Back Exit CH RTN EXIT
Installation
Sleep Timer
On/Off Timer
Setup
PC Settings
HDMI 1 Audio Auto
Auto
2 Sec
HDMI 2 Audio
Slide Show Interval
3. A new set of Installation menu icons will appear on-screen,
as shown below. Open the Terrestrial menu, highlight
Signal Meter, and press ENTER.
Terrestrial
Input Configuration
Channel program
Channel Add/Delete
Signal Meter
Navigate Select Back Exit CH RTN EXIT
4. Press yzx • to select the antenna input and digital
channel whose signal you want to check.
Note: The physical digital channel number listed in the Signal
Meter screen may not correspond to a virtual TV channel
number. Contact your local broadcasters to obtain the RF
channel numbers for your local digital stations.
Signal Meter
Antenna 1
Physical Digital Channel 13
Virtual Digital Channel
Done
N/A
Signal Locked
0 0 Peak
To close the screen and return to the Terrestrial menu:
Highlight Done and press ENTER.
To return to normal viewing:
Press EXIT.