Quatech Device Server - Manual (Page 68)

Configuring the SDS using a Web interface Quatech SDS User’s Manual
Page 62 940-0183-154 October 2006
If you have an RS-232 SDS, the Configure
Serial Port Interface step will not display
and you will not be presented with any RS-
422/485 configuration options.
Figure 54 - Serial Port Setup screen for Raw TCP mode
Step Procedure Description
‰
Step 1 Select the serial port you want to
configure.
Click on a port number to select that
port. The selections on the screen are
automatically populated with any
existing parameters for the selected port.
‰
Step 2 Click on the Raw TCP operating mode
selector.
Raw TCP allows an SDS device to
communicate without any protocol
overhead.
You will find directions for configuring
ports in Normal and Tunneling modes
in the preceding sections. Directions for
Auto TCP and Raw UDP modes are in
the following section.
‰
Step 3a Configure the Operating mode.
Click on the desired data Rate Multiplier.
Your choices are:
¾ Auto (Recommended)
The auto setting has no effect on the
baud rate you set. However, if you select
X2, X4, or X8, the baud rate of the serial
port will be the baud rate that you set
multiplied by 2, 4, or 8, respectively.
Note: Click on a link
to see a pop-up help
screen for that item.