Quatech Device Server - Manual (Page 23)

Quatech SDS User’s Manual Installing the device drivers
October 2006 940-0183-154 Page 17
Figure 7 - Welcome screen
Step Procedure Description
Step 5 Click the Next button to continue. The Prepare to Install screen displays.
Continue with □ Step 6.
Figure 8 - Prepare to Install screen
Step Procedure Description
Step 6 Connect the Ethernet port on your SDS to
one of the following:
¾ Desired installation location,
¾ Hub on your local subnet, or
¾ Network Interface Connection (NIC)
on your computer using an Ethernet
crossover patch cable.
If you cannot immediately attach the SDS
to the target installation site, temporarily
attach it to the local hub or your computer’s
NIC for configuration purposes.
Notes: Use a CAT5 or better Ethernet cable
to attach the SDS to your network.
If your SDS is pre-configured for your
network, attach it now to the appropriate
subnet location.
Continue with □ Step 7.
Figure 8 illustrates the Quatech
Install Wizard’s Welcome
screen.
Figure 9 illustrates the Prepare
to Install prompt. Be sure to
read this screen carefully
before proceeding.
Note: Press the Help key for
additional information as you
go through the installation
procedure.