Omnitron Systems Technology RS-232 - Manual (Page 54)

Appendix A
DEFAULT SETTINGS
The Omni reader is shipped from the factory with the following bar code
default settings already programmed:
Terminal Selection
Type RS-232 (Serial)
General Selection
Beep Volume High
Interblock Delay 0 milliseconds
Code ID Off
Scan Verification Off
Automatic Verification 01
Bar Code Message Formatting
Terminator Character CRLF
Preamble None
Postamble None
Magentic Stripe Message Formatting
Terminator Character CRLF
Preamble None
Postamble None
RS-232 Port Settings
Baud Rate 9600
Data Bits 8
Parity None
Handshaking X-On/X-Off
Stop Bit(s) 1
X-On DC1 (\11)
X-Off DC3 (\13)
48