Omnitron Systems Technology RS-232 - Manual (Page 15)

9
Code ID Definition (Group I)
If the Code ID option is enabled in General Setup, the user can select the
character used to identify each symbology.
1. Enter CODE ID DEFINITION SETTINGS MODE by typing /E/D/FI.
2. Press . The reader should beep twice.
3. Enter the characters in the left column to select the symbology.
4. Press . The reader should beep twice.
5. Enter one character for the new ID.
a UPC-A Default = a
b UPC-E Default = b
c EAN-8 Default = c
d EAN-13 Default = d
e Code 39 Default = e
f Interleaved 2 of 5 Default = f
g Industrial 2 of 5 Default = g
h Code 128 Default = h
i MSI/Plessey Default = i
j Codabar Default = j
k MSR Track 1 Default = k
l MSR Track 2 Default = l
m MSR Track 3 Default = m
n Telepen Default = n
6. Press . The reader should beep twice.
7. Save the change and exit the group setup mode by entering IZ.
The reader should beep four times.
Note: To review the group’s current setting(s), type IY while in the Group
Setup Mode. To reset the current setting(s) to its group default, type IX
while in the Group Setup Mode.
EXAMPLE:
To change Code ID for Code 128 from h to w, enter:
/E/D/FIhwIZ