Omnitron Systems Technology RS-232 - Manual (Page 35)

29
EXAMPLE:
To review the reader’s current settings for the Code 39 bar code, first find
the settings for Code 39 listed in the Industrial Bar Codes setup group. (The
single alpha character group name is F.) Then in Notepad type:
/E/D/FFFY
A sample response is shown below.
Remember to end the review by typing: FZ This will take the
reader out of the setup mode and bring it back into its normal reading mode.
=======================================================
Industrial Bar Code Setting
Code 39 Enabled; Full ASCII Off
Min Length = 01; Max Length = 60; No Check Digit; Stop-Start Send
I 2 0f 5 Enabled; Fixed Length Off
Min Length = 01; Max Length = 60; No Check Digit
FEBRABAN Enabled
S 2 of 5 Enabled; Fixed Length Off
Min Length = 01; Max Length = 60; No Check Digit
Code 128 Enabled
Min Length = 01; Max Length = 60
Codabar Enabled; StopStart Not Send
Min Length = 01; Max Length = 60; No Check Digit
MSI Enabled; Check Digit Not Send
Min Length = 01; Max Length = 60; Check Digit Double Modulo 10
Telepen Enabled, ASCII Mode
Min Length = 01; Max Length = 60
=======================================================