Onkyo TX-SR573 - Manual (Page 53)

53
Advanced Setup—Continued
Notes:
• A quick way to adjust the speaker levels is to press the
remote controller’s [TEST TONE] button to turn on
the test tone. Use the [LEVEL–] and [LEVEL+] but-
tons to adjust the levels, and use the [CH SEL] button
to select the speakers.
• If the multichannel DVD input is selected (page 35),
in step 2, “3. MultiLevel” appears instead of “3. Level
Cal,” and you can adjust the level of each channel of
the multichannel DVD input. These level settings are
independent of the Speaker Configuration settings on
page 32.
The following table shows the display indicator for each
digital signal format.
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can specify the signal format as either PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try the PCM setting.
• If noise is produced when fast forwarding or reversing
a DTS CD, try the DTS setting.
4 Use the Left and Right [ ]/[ ]
buttons to adjust the speaker
level, and use the Down [
] but-
ton to select the next speaker.
The levels can be adjusted from –12 to
+12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
5 Repeat step 4 so that the level of
the test tone coming from each
speaker is the same.
Speakers that you set to No or None in
the Speaker Configuration (page 32) do
not output the test tone.
6 Press the [SETUP] button.
Setup closes.
Don’t forget to turn down the volume if
you turned it up while setting the levels.
ENTER
ENTER
Digital Signal Formats
Format Display
Dolby Digital
DTS
PCM
1 Press and hold the AV receiver’s [DIGITAL
INPUT] button for about 3 seconds.
2 While “Auto” is displayed (about 3 sec-
onds), press the [DIGITAL INPUT] button
repeatedly to select: PCM, DTS, or Auto.
PCM: The PCM indicator flashes, and only input
signals in PCM format will be output.
DTS: The DTS indicator flashes, and only input
signals in DTS format will be output.
Auto (default): The format is detected automati-
cally. If no digital input signal is present, the cor-
responding analog input is used instead.
PCM
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE RETURN
TUNING / PRESET
ENTER
SETUP
STANDBY
STANDBY/ON
CLEAR
PHONES MULTl CH DVD VIDEO 1 VIDEO 2
VCR
VIDEO 3 TAPE TUNER CD VIDEO
VIDEO 3 INPUT
AUDIO L R
MASTER VOLUME
A SPEAKERS B
DIGITAL INPUT