Onkyo TX-SR573 - Manual (Page 35)

35
Playing Your AV Components—Continued
The multichannel DVD input is for connecting a compo-
nent with a 5.1-channel analog audio output, such as a
DVD-Audio or SACD-capable DVD player, or an
MPEG decoder. See page 23 for hookup information.
Note:
• While the multichannel DVD input is selected, the
Speaker Configuration settings on page 32 are
ignored, and signals from the multichannel DVD input
are fed to the front left, front right, center, surround
left, and surround right speakers, and subwoofer as
they are.
You can display various information about the current
input source as follows.
The following information can typically be displayed:
*If the input signal is analog, no format information is
displayed. If the input signal is PCM, the sampling fre-
quency is displayed. If the input signal is digital but not
PCM, the signal format is displayed. Information is dis-
played for about 3 seconds, then the previous display
reappears.
Interpreting Surround Channel Information
A: The number of front channels (front left, front right,
and center).
B: The number of surround channels (surround left and
surround right). If there’s surround back channel
information, this number will be 3.
C: LFE channel for subwoofer (1 means yes).
Using the Multichannel DVD Input
Press the [RECEIVER] REMOTE
MODE button, followed by the
[MULTI CH] button.
The MULTI CH indicator appears on
the display.
Audio from the multichannel DVD
input will now be used for the DVD
input source.
10 - - / - - - 11 12
REMOTE MODE
HDD RECEIVER
TAPE/AMP
DVD CD
SAT TV VCR CABLE
MD CDR
STEREO SURR
DIRECT
SUBTITLE AUDIO
ALLST
PLAY MODE
TEST TONE CH SEL
VIDEO OFF
REPEAT
RANDOM REC
SP A SP B
PLAYLIST
OPEN/CLOSE
LEVEL LEVEL
L NIGHT CINE FLTR
+
-
TV CH
TV VOL
ENTER
SET UP
RE TURN
TO P M ENU MEN U
VOL
+
-
CH
DISPLAY
PREV
CH
DIMMER SLEEP
MUTING
LISTENING MODE
INPUT SELECTOR
3 2
MACRO
1
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
INPUT I
ON STANDBY
TV
CD
V1 V2 V3
MULTI CH DVD
TAPE TUNER
DISC
ALBUM
RC-632M
DISPLAY
RECEIVER
MULTI CH
RECEIVER
5
MULTI CH
MULTI CH indicator
Displaying Source Information
Press the [RECEIVER] REMOTE
MODE button, and then press the
[DISPLAY] button repeatedly to
cycle through the available infor-
mation.
DISPLAY
RECEIVER
Input source &
volume
Signal format*
or sampling
frequency
Input source &
listening mode
A B C