Onkyo TX-SR573 - Manual (Page 51)

51
Advanced Setup
Crossover Frequency
To get the best bass performance from your speaker sys-
tem, you need to set the crossover frequency according
to the size and frequency response of your subwoofer
and other speakers.
Note:
• For a more accurate setting, look up the frequency
response in the manuals supplied with your speakers
and set accordingly. In addition, listen to some music
that you know well and choose a higher crossover fre-
quency if you think there’s not enough sound coming
from the subwoofer; a lower setting if you think
there’s too much.
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left and right
channels to the subwoofer. This function can only be set
if in the Speaker Configuration on page 32, the Sub-
woofer setting is set to Yes (step 3), and the Front setting
is set to Large (step 4).
Advanced Speaker Settings
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
2 Use the Up and Down [ ]/[ ]
buttons to select “1. Speaker
Config,” and then press the
[ENTER] button.
3 Use the Down [ ] button to
select “Crossover,” and then use
the Left and Right [
]/[ ] but-
tons to select a crossover fre-
quency.
Choose a crossover frequency suitable
for your setup.
If you’re using a subwoofer, choose a
crossover frequency based on the diam-
eter of your front speakers.
If you’re not using a subwoofer, use
the diameter of the first speaker that
you specified as Small in steps 4
through 7 of the Speaker Configuration
on page 32.
The advanced speaker settings cannot be
changed while headphones are connected,
speaker set B is on, or the multichannel DVD
input is selected.
RECEIVER
ENTER
ENTER
ENTER
ENTER
Continue with step 4, “Double Bass.”
4 Use the Down [ ] button to
select “Double Bass,” and then
use the Left and Right [
]/[ ]
buttons to select:
On: Double Bass function on.
Bass from the front left and
right channels is also fed to
the subwoofer (default).
Off: Double Bass function off.
5 Press the [SETUP] button.
Setup closes.
Speaker cone
diameter
Crossover
frequency
Over 8 in.
(20 cm)
60Hz
6-1/2 to 8 in.
(16–20 cm)
80Hz
5-1/4 to 6-1/2 in.
(13–16 cm)
100Hz (default)
3-1/2 to 5-1/4 in.
(9–13 cm)
120Hz
Under 3-1/2 in.
(9 cm)
150Hz
ENTER
ENTER