Onkyo TX-SR573 - Manual (Page 30)

30
Turning On the AV Receiver
Note:
Pressing the remote controller’s [ON] button once will turn on the AV receiver. Pressing it again will turn on any
components connected via
.
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE RETURN
TUNING / PRESET
ENTER
SETUP
STANDBY
STANDBY/ON
CLEAR
PHONES MULTl CH DVD VIDEO 1 VIDEO 2
VCR
VIDEO 3 TAPE TUNER CD VIDEO
VIDEO 3 INPUT
AUDIO L R
MASTER VOLUME
A SPEAKERS B
STANDBY/ON
10 - - / - - - 11 12
REMOTE MODE
HDD RECEIVER
TAPE/AMP
DVD CD
SAT TV VCR CABLE
MD CDR
+
-
TV CH
TV VOL
DIMMER SLEEP
INPUT SELECTOR
3 2
MACRO
1
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
INPUT I
ON STANDBY
TV
CD
V1 V2 V3
MULTI CH DVD
TAPE TUNER
ON
RECEIVER
STANDBY
STANDBY indicator
Turning On & Standby
Press the [STANDBY/ON] button.
Alternatively, press the remote controller’s [RECEIVER] button, followed
by the [ON] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
To turn the AV receiver off, press its [STANDBY/ON] button, or press the remote con-
troller’s [STANDBY] button. The AV receiver will enter Standby mode. To prevent any
loud surprises when you next turn on the AV receiver, always turn down the volume
before you turn it off.
STANDBY/ON
ON
Remote
controller AV receiver
or
RECEIVER
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Have you connected a component to a digital audio input?
If you have, see “Assigning Digital Inputs to Sources” on page 31.
■ Have you connected an Onkyo MD recorder, CD recorder, or next generation HDD-compatible
component?
If you have, see “Changing the Input Display” on page 31.
■ Do the speaker configuration—this is essential!
See “Speaker Configuration” on page 32.
OPT1
COAX
OUT IN
TAPE
CD recorder, MD recorder,
RI Dock, etc.