OTC Wireless switch/hub - Manual (Page 32)

22
Datastream Functions
ABS / Air Bag 2004 User Guide
Graph / Analog / LED / Digital
The Graph/ Analog / LED / Digital function lets you
change the display type for each line on the Datastream
screen. Depending on the type of data on a line, you
can change a selected line from digital to a graphical
or LED display. You can also set some of the lines to
display analog meters (gauges) at the top of the screen.
To change the display for each line, follow these steps:
Figure 3.5: Datastream Screen - Digital Display
1 With the Datastream screen displayed, use the Up or
Down Direction key to select the line to change.
2 Press the Graph / Analog / LED / Digital function key.
Note: This name of this function key changes each time
you press the key. The name of the key represents the
next display type that will appear when you press the key.
3 Repeat steps 1 and 2 for each line to change.
About Digital Display
When a line is displayed as Digital, its reading is a word
or a number as shown for all the lines in
Figure 3.5 .
You can change the display of the lines as follows:
• If the selected line’s data reading is a word, such as On,
Off, Open, Closed, etc., then you can change the line’s
display back and forth between LED and Digital.
• If the selected line’s data reading is a number, such as 1.1
V, 23.3 Amps, etc., then you can change the line to also
display as either a graph or an analog gauge.
About LED Display
If a selected line’s data reading is a word (such as On,
Off, Open), you can use the LED function key to change
the line to display as an LED bar. For example, see
Fig-
ure 3.5 and Figure 3.6 . Notice how the function key
changes to toggle back and forth between LED and
Digital.
Figure 3.6: Datastream Screen - LED Display Function