Omega Engineering OMEGASCOPE OS533 - Manual (Page 57)

Troubleshooting Guide
6
1. The line of sight and the center
of the target are offset by design.
(refer to Figure 3-4 and the
explanation above it for how
to compensate for this).
Problem Solution
The trigger is pulled two times in
rapid sequence. Wait at least 2
seconds between two successive
trigger pulls. You may need to set
the emissivity, low alarm, high
alarm, target ambient temperature
values again. The thermometer resets
itself unexpectedly.
The emissivity has been
reset to .95. All other
parameters are reset to
the default values.
6-4
Laser Sighting
Problem Solution
No Laser Beam 1. Make sure the trigger is pulled
and the laser power switch is
turned on. (The red power LED
should be lit).
The Laser "line of sight"
does not coincide
with the center of the
target.