Omega Engineering OMEGASCOPE OS533 - Manual (Page 33)

°F PRN
NOTE
°F ATC
NOTE
Using the Handheld Infrared Thermometer
2
2-18
8. Press and hold the key until the Emissivity Display
Mode (E) appears.
9. Change the emissivity to the proper value for the target
being measured (refer to Section 2.3.1).
10. Aim at the target. The target temperature and emissivity
are displayed on the LCD.
11. After all data is taken, press the key to release
this mode
To disable the Ambient Target Temperature
Compensation at a later time, you must press the
key to get into the Ambient Target
Temperature Display Mode. Then press the
key to disable it.
The target ambient temperature does not change
when the thermometer is turned off. However,
when the batteries are replaced, it is reset to the
default value of 75°F.
2.3.9 Sending Temperature Data to a Serial Printer
(OS533, OS534, OS523, OS524)
The thermometer can transmit temperature data to a Serial
Printer via the RS-232 phone jack and the RS-232 cable.
1. Turn on the Serial Printer and set the following
parameters:
Speed: 4800 BPS One Stop Bit
Data: 8 Bits No Parity
2. Connect the RS-232 cable between the thermometer and
the printer as shown in Figure 2-14.