Omega Engineering OMEGASCOPE OS533 - Manual (Page 34)

Figure 2-14. Serial Printer Hookup
3. Pull the trigger and press the key to lock the
trigger. The icon will appear on the display.
4. Press and hold the until the Print Data display
Mode (PRN) appears.
5. Press the key to increment the printing interval. Press
the key to decrement the printing interval. The
printing interval (from 1 to 1999 seconds) is the time
between data points. The default value is 2 seconds.
6. Press the key to start sending data. The
icon appears on the display.
To stop sending data, press the key again, and
the icon disappears.
RS-232
Digital
Cable
NOTE
Bottom hole is
the RS-232 jack
25-pin 'D'
Connector
6-pin
Phone Jack
To the
Printer
To the
Thermometer
Serial Printer
NOTE
°F PRN
2-19
Using the Handheld Infrared Thermometer
2