Omega Engineering OMEGASCOPE OS533 - Manual (Page 45)

2.6.3 Reviewing Previously Stored Temperature Data
(OS534, OS523, OS524)
You can review all 100 stored temperature values on the
thermometer display using the following procedure:
1. Press and hold the key until you see the Memory
Display Mode (MEM) appear.
2. Press the key to increment the memory location or
press the key to decrement the memory location.
The memory location can be from 001 to 100.
3. Press the key. The stored temperature is shown in
the lower portion of the display. If there is no data stored
in a memory location, the display shows “----”.
4. To review other stored temperatures, repeat Steps 2
and 3.
If no keys are pressed, the thermometer goes into sleep
mode in approximately 10 seconds.
NOTE
°F
Using the Handheld Infrared Thermometer
2
2-30