Omega Engineering OMEGASCOPE OS533 - Manual (Page 39)

Using the Handheld Infrared Thermometer
2
2-24
2.3.11 Storing the Temperature Data on Command
(OS534, OS523, OS524)
The thermometer can store up to 100 temperature data
points on command. Each set of temperature data is broken
down into the temperature value, emissivity, and high
alarm setpoint for that temperature. This data is stored in
non-volatile memory, so removing the batteries will not
affect this data. To store temperature data:
1. Aim at the target and pull the trigger and press the
key to lock the trigger. The icon will appear
on the display.
2. If necessary, press the key to increment the target
emissivity or press the key to decrement the target
emissivity.
3. Press and hold the key until the Memory Display
Mode (MEM) appears.
4. Press the key to increment the memory location or
press the key to decrement the memory location.
The memory location can be from 001 to 100.
5. Press the key to store the target temperature at the
memory location indicated. You will hear a beep to
verify that the data is stored.
You can write over any previously stored
memory locations.
6. After all data is taken, press and hold the key
until the Emissivity Display Mode (E) appears.
7. Press the key to unlock the trigger.
NOTE
°F