Onkyo TX-DS989 - Manual (Page 60)

60
OPEN/CLOSE REC
AUDIO MUTING
DISC TRACK
DVD CD
PH TUN T2 T1
V1
STEREO
1 2 3
6 5 4
7
+ 10 0 ENT
8 9
SURROUND THX DSP
LEVEL + CH SEL Re-EQ
LEVEL – DIMMER
HOME THEATER CONTROLLER
RC-390M
LATE NIGHT
DIRECT DSP
V2 V3 V –
SAT, CABLE, VCR,
and TV MODE
OPEN/CLOSE REC
AUDIO MUTING
DISC TRACK
DVD CD
PH TUN T2 T1
V1
STEREO
1 2 3
6 5 4
7
+ 10 0 ENT
8 9
SURROUND THX DSP
LEVEL + CH SEL Re-EQ
LEVEL – DIMMER
HOME THEATER CONTROLLER
RC-390M
LATE NIGHT
DIRECT DSP
V2 V3 V –
DVD MODE
MENU
DVD SET
DVD
operation
buttons
Numeric keys,
ENT
POWER ON POWER
STNBY
RETURN
ENTER/
Cursor
button
Using remote controller
Controlling an Onkyo DVD player
Make sure that you point the remote controller toward the sensor
on the Onkyo DVD player.
1. Press the DVD MODE button.
“DVD” appears in the remote controller display.
2. Press the desired operation button. The
buttons shaded in the figure to the left are the
operation buttons that can used to control an
Onkyo DVD player.
POWER ON/STNBY: Turns the DVD player on and off
DVD SET: Enters the DVD setup menu
DVD player on-screen buttons
MENU: Displays the menu
: Moves the cursor
ENTER: Confirms the selection
RETURN : Return buttons
DVD player buttons
: Chapter/Track Down
: Chapter/Track Up
: Play
: Stop
: Fast Reverse
: Fast forward
: Pause
OPEN/CLOSE r: Open/close the disc tray
0, 1 to 9, +10: Numeric keys
ENT: Confirm
You may also use the following buttons:
VOL : Adjusts the volume at the TX-DS989
MUTING: Activates the muting function at the TX-DS989
Note:
The ENT button on the bottom right of the numeric keys has the
same function as “ENTER” of the ENTER/cursor button.
SAT, CABLE, VCR, and TV MODE buttons
No preset codes are programmed into the SAT, CABLE, VCR, and
TV MODE buttons. You can use these buttons to program the
remote controller signals of other devices (see page 61).
You may use the following buttons:
VOL : Adjusts the volume at the TX-DS989
MUTING: Activates the muting function at the TX-DS989