Onkyo TX-DS989 - Manual (Page 47)

47
Preference
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.Zone2 OSD Setup
6.About
Select: Exit:|EXIT|
Enter:|ENTER| Quit:|OSD|
1
2
3
4
5
6
7
8
9
0
1
2
123456789012345678901234
4.Preference
1.Volume Setup
2.OSD Setup
3.OSD Tweak
Quit:|OSD|
1
2
3
4
5
6
7
8
9
0
1
2
123456789012345678901234
4-3.OSD Tweak
Exit:|EXIT|
4-3. OSD Tweak
This setting allows you to adjust the position of the OSD menu as
it is displayed on your screen. Depending on the monitor used,
there may be cases where the OSD menu is not displayed in the
center and parts of the menus are cut off. To adjust the position of
the OSD menu, simply press the cursor buttons to inch the menu to
position you desire.
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.Zone2 OSD Setup
6.About
Select: Exit:|EXIT|
Enter:|ENTER| Quit:|OSD|
1
2
3
4
5
6
7
8
9
0
1
2
123456789012345678901234
4.Preference
1.Volume Setup
2.OSD Setup
3.OSD Tweak
Quit:|OSD|
1
2
3
4
5
6
7
8
9
0
1
2
123456789012345678901234
4-2.OSD Setup
a.Background Color
:Blue1
b.Superimpose Mode
:Off
c.Immediate Display
:On
d.Display Position
:Top
e.Timeout :2sec
4-2. OSD Setup sub-menu
This sub-menu allows you to customize the OSD menu to display
in the manner you desire.
a. Background Color
Select either Blue1, Blue2, Green1, Green2, Magenta, Red1, or
Red2 as the background color while the OSD menu is displayed.
b. Superimpose
Off: Select to have the OSD menu displayed on the selected
background color.
Normal: Select to have the OSD menu superimposed over the
current video if one is displayed or on the selected background
color if there is no video signal.
Black: Select to have the OSD menu displayed on a black
background at all times.
c. Immediate Display
On: Select this to have the screen immediately display certain
operations as you perform them and maintain the display for a
set amount of time after you are finished. For example, if you
change the volume, the volume level will appear on the screen
as it is changed.
Off: Select this to turn off the immediate display of operations.
Volume dB
Note:
The name that you input at the Character Input sub-menu (page
41) will not be reflected by the immediate display displayed when
the input source is changed. For example, if your second DVD
player is connected to VIDEO 5 and you change its name to
“DVD-2,” when it is selected as the input source, the immediate
display still reads “VIDEO 5.”
d. Display Position
Use this setting to select the position of the immediate display that
appears when certain operations are performed. You can position
the immediate display at any of ten different levels ranging from
the top all the way to the bottom.
e. Timeout
Use this setting to select the amount of time the immediate display
remains after the operation is completed. You can have the
immediate display remain for 2, 3, 4, or 5 seconds.