Onkyo TX-DS989 - Manual (Page 54)

54
Notes:
• If you change the input source during recording, you will
record the signals from the newly selected input source.
• You cannot record the surround effects.
• Digital signals input to the DIGITAL INPUT (COAXIAL) and
DIGITAL INPUT (OPTICAL) inputs will be output to the
DIGITAL OUTPUT (COAXIAL) and DIGITAL OUTPUT
(OPTICAL) outputs.
• Digital input signals are only output to the digital outputs and
analog input signals are only output from the analog outputs.
There is no conversion from digital to analog or vice versa.
When connecting CD players and other digital components, do
not connect only the digital terminals, but the analog ones as
well.
• There are some restrictions on recording digital signals. When
making digital recordings, consult the instruction manual that
came with your digital recording equipment (e.g., MD
recorder or DAT deck) to know what restrictions are imposed.
• You cannot record the source connected to the MULTI
CHANNEL INPUT connector.
Of course the TX-DS989 can also be used to record an input
source media. This allows you to make copies of the music or
videos you like, copy them from one type of media to another, or
even record what is being broadcast on television or radio. Be
aware that the Rec Out and Zone 2 buttons use the same circuit so
that you cannot make recording and output to the remote zone
(Zone 2) at the same time.
To record the input source signal you are
currently watching or listening to
This method outputs to the audio and video outputs the currently
selected input source signal. This method allows you to a signal
while you are actually listening to or watching it.
1. Select the input source to record by pressing
the corresponding input selector button.
The input source is now selected and you may watch or listen
to it as desired.
2. Press the Rec Out button twice within 8
seconds.
Pressing the Rec Out button twice outputs the currently
selected input source signal to the TAPE 1 OUT, TAPE 2
OUT, VIDEO 1 OUT, and VIDEO 2 OUT outputs for
recording. The indicator above the selected input source lights
red.
3. Start recording at the recording component as
desired.
To confirm the settings, press the Rec Out button. The current
settings will appear for 8 seconds in the front display.
Recording a source
OFF ON
STANDBY/ON
STANDBY
MASTER VOLUME
DISPLAY DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 VIDEO 5 TAPE 1 TAPE 2 AM FM PHONO C D OPEN/CLOSE
PHONES CLEAR
ZONE 2 ( ) GRN
REC ( ) RED
POWER
AV RECEIVER TX-DS 989
Rec Out
Input selector buttons