Onkyo TX-DS989 - Manual (Page 49)

49
Enjoying music or videos in the remote zone
Controlling the TX-DS989 from the remote zone
1. Aiming at the remote sensor, press the
POWER ON button on the remote controller.
Note:
Be aware that if you start using the system in the remote zone
(Zone 2) while a recording is going on in the main zone, the
recording is aborted.
2. Press the appropriate input selector button on
the remote controller to select the desired
source.
3. Adjust the volume on the power amplifier to
the desired level.
Controlling the TX-DS989 without the remote
controller
1. Press the Zone 2 button on the TX-DS989.
2. Select a source.
After pressing the Zone 2 button, you must press an input
source button within 8 seconds. To select the same source as
that selected for the main zone, press the Zone 2 button twice
in succession. The indicator above the selected input source
will light green. Adjust the volume in the remote zone as
desired.
Notes:
• If the Zone 2 button was pressed twice so that the same source
is being played in the main and remote zones, then changing
the input source in the main zone also changes the input source
for the remote zone.
• In the remote zone, you can only play the source in the 2-
channel mode. You cannot play the source in the remote zone
in the surround mode.
• If the Rec Out button is pressed in the main room while
someone is using the system in the remote zone, the Zone 2
function will be deactivated and the source will turn off in the
remote zone.
• The Zone 2 terminal is an analog output. Digital signals are not
output. If no sound is heard from the selected input source,
check if the component is connected to the analog inputs.
• Please note that some third-party multi-room system
components may not be fully compatible with the Onkyo
multi-room system components.
• If you are not using the system in the remote zone, always
press the Zone 2 button and then the Off button to turn the
Zone 2 function off.
Ex.: When the Zone 2 button is pressed twice
Ex.: When the Zone 2 button and then VIDEO 4 button are
pressed
OFF ON
STANDBY/ON
STANDBY
MASTER VOLUME
DISPLAY DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 VIDEO 5 TAPE 1 TAPE 2 AM FM PHONO C D OPEN/CLOSE
PHONES CLEAR
ZONE 2 ( ) GRN REC ( ) RED
POWER
OPEN/CLOSE REC
AUDIO MUTING
DISC TRACK
DVD CD
PH TUN T2 T1
V1
STEREO
1 2 3
6 5 4
7
+ 10 0 ENT
8 9
SURROUND THX DSP
LEVEL + CH SEL Re-EQ
LEVEL – DIMMER
HOME THEATER CONTROLLER
RC-390M
LATE NIGHT
DIRECT DSP
V2 V3 V –
POWER
ON
Zone 2 Off
Input
selector
buttons
VOL
AV RECEIVER TX-DS 989