Onkyo TX-DS989 - Manual (Page 22)

22
Assembling the AM loop antenna
Assemble the loop antenna as shown in the illustration.
• Refer to the next page for details on connecting the AM loop
antenna.
Connecting the AM antenna cable
1. Press down the lever.
2. Insert the wire into the hole.
3. Release the lever.
1 2 3
Insert into the hole.
AM
FM
75
ANTENNA
Connecting antennas
Connecting the included antennas
Connecting the FM indoor antenna:
The FM indoor antenna is for indoor use only. During use, extend
the antenna and move it in various directions until the clearest
signal is received. Fix it with push pins or similar implements in
the position that will cause the least amount of distortion.
If the reception is not very clear with the attached FM indoor
antenna, the use of an outdoor antenna is recommended.
Connecting the AM loop antenna:
The AM loop antenna is for indoor use only. Set it in the direction
and position where you receive the clearest sound. Put it as far
away as possible from the TX-DS989, televisions, speaker cables,
and power cords.
When reception is not satisfactory with the attached AM loop
antenna alone, connection of an outdoor antenna is recommended.
Strip away the insulation
from the end of the cable,
then fully insert the stripped
end of the cable.
U.S. and Canadian models
FM antenna
(indoor)
AM loop antenna