Settings required for the mail receive function – Omron CS CJ1W-ETN21 User Manual
Page 63
39
Using the Mail Receive Function
Section 3-3
3-3-2
Settings Required for the Mail Receive Function
The following Unit settings must be made when using the Mail Receive Func-
tion.
Note
Make DNS settings when the Server specification type is set to Host name in
the SMTP or POP Tab.
CX-Programmer
Unit Setup Tab
Setting
Setting requirement
Reference
SMTP
Server specification type Required.
IP Address
One or the other is required, depending on the
Server specification type setting.
Host name
Port No.
Rarely required (when a setting other than the
default setting of 25 is required).
Local mail address
Required.
Use POP before SMTP
Required when the account must be authenti-
cated with POP3 before sending mail.
POP
Server specification type Required.
IP Address
One or the other is required, depending on the
server specification method setting.
Host name
Port No.
Rarely required (when a setting other than the
default setting of 110 is required).
Account Name
Required when the account name is different
from the name up to the @ symbol in the e-mail
address. (9 characters max.)
Mail password
Required. (8 characters max.)
Server access interval
time
Optional (Change when the default setting of 5
minutes is unacceptable.)
DNS
(See note.)
IP Address
Required.
Port No.
Rarely required (when a setting other than the
default setting of 53 is required).
Retry timer
Optional (Change when the default setting of 10
seconds is unacceptable.)
Receive Mail
Mail address
Select the Protect using mail address Option
when you do not want to receive mail from
addresses other than the specified address.
Receive file with speci-
fied extension only
Select this option when you do not want to
receive attached files other than the specified
types.
Receive specified com-
mands only
Select this option when you want to specify the
remote mail commands that can be received.