Omron CS CJ1W-ETN21 - Manual (Page 147)

123
Using Socket Services by Manipulating Dedicated Control Bits Section 6-7
Note These response codes will be returned only on large, multilevel networks.
TCP Socket Receive Request
000D Remote IP address parameter error (EACCES).
003E Internal buffer cannot be obtained due to high reception traffic
(ENOBUFS).
0042
(See note.) Error (EMSGSIZE).
0044 ICMP data received (ENOPROTOOPT).
0045 Error in communications with remote node (ECONNABORTED).
0049 The same port number has been specified more than once (EAD-
DRINUSE).
004A Error (ECONNREFUSED) or the remote node has not been opened
as passive socket.
004B
(See note.) Error in communications with remote node (ECONNRESET).
004C Remote IP address parameter error (EADDRNOTAVAIL).
Wrong parameter designation.
An attempt was made to set the local TCP port of the local node to
Active Open.
004E Remote IP address parameter error (ENETUNREACH).
The network ID is not in the IP router table or router settings are
incorrect.
0051 Remote IP address parameter error (EHOSTUNREACH).
The router settings are incorrect.
0053 Communications error with remote node (ETIMEDOUT).
No remote node.
0081 The specified socket was closed during open processing.
Response
code
Meaning
0000 Normal end
0302 CPU Unit error; cannot execute.
1100 Number of receive bytes not in allowable range.
1101 The area designation of the Send/Receive Data Address is not in
allowable range.
1103 The bit number in the Send/Receive Data Address is not 00.
110C Request Switch turned ON during other processing.
220F Specified socket is already processing a receive request.
2210 Specified socket has not been connected.
2211 Unit is busy; cannot execute.
2607 Specified Socket Service Parameter Area is already being used for
another socket.
003E Internal buffer cannot be obtained due to high reception traffic
(ENOBUFS).
0042
(See note.) ICMP data received (EMSGSIZE).
0044
(See note.) ICMP data received (ENOPROTOOPT).
0045
(See note.) Error in communications with remote node (ECONNABORTED).
004B Error in communications with remote node (ECONNRESET).
004E
(See note.) ICMP data received (ENETUNREACH).
Response
code
Meaning