Renesas HS2378KCI01H - Manual (Page 41)

17
7. Supply power to the user system.
The subsequent procedures depend on the activation mode that was selected in step 5.
2.5.1 H8S/xxxx E10A Emulator Mode
This mode is used for debugging in the emulator.
1. After the [System Clock] window appears, input the system clock frequency. This frequency
value is used when writing and erasing flash memory in the emulator.
Figure 2.8 [System Clock] Dialog Box
2. Set an eight-digit hexadecimal ID code as a security code for the flash memory. Input this ID
code when [H8S/xxxx E10A Emulator] is selected and the [New registration] check box is
unselected on activating the HDI. If the ID code is not matched, the flash memory contents
are erased.
Figure 2.9 [ID Code] Dialog Box
3. When "Link up" appears on the status bar, the user and emulator programs have been
downloaded to the flash memory, and the HDI initialization is complete.
Figure 2.10 [HDI] Status Bar