Renesas HS2378KCI01H User Manual
Page 151
127
Table 6.6 Conditions Set in [Break condition] Dialog Box
Condition
Dialog Box
Address Bus
Condition
Data
Condition
Read or write
condition
[Break condition 1]
O
O
O
[Break condition 2]
O
O
O
Note:
O: Can be set by checking the radio button in the dialog box.
Table 6.7 lists the combinations of conditions that can be set by the BREAKCONDITION_SET
command.
Table 6.7 Conditions Set by BREAKCONDITION_SET Command
Condition
Channel
Address Bus
Condition
(
Data
Condition
(
Read or write
condition
(
Break condition 1
O
O
O
Break condition 2
O
O
O
Note:
O: Can be set by the BREAKCONDITION_SET command.
Notes on Setting the Break Condition:
1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Break
Condition are disabled.
2. The settings of Break Condition is disabled when an instruction to which a software
breakpoint has been set is executed.
3. When step over function is used, the settings of software breakpoint and Break Condition are
disabled.