Renesas HS2378KCI01H - Manual (Page 123)

99
5.2 Command Descriptions
The command list of the E10A emulator is shown below.
Table 5.1 E10A HDI Commands
No Command Abb. Function
1 BREAKCONDITION_
CLEAR BCC Clears hardware breakpoints that have been set.
2 BREAKCONDITION_
DISPLAY BCD Displays hardware breakpoints that have been set.
3 BREAKCONDITION_
ENABLE BCE Enables or disables hardware breakpoints that have
been set.
4 BREAKCONDITION_
SET BCS Sets hardware breakpoints.
5 BREAKPOINT BP Sets software breakpoints.
6 BREAKPOINT_CLEAR BC Clears software breakpoints that have been set.
7 BREAKPOINT_DISPLAY BD Displays software breakpoints that have been set.
8 BREAKPOINT_ENABLE BE Enables or disables software breakpoints that have
been set.
9 DEVICE_TYPE DE Displays MCU type currently selected.
10 GO_OPTION GP Sets or displays the emulation mode during user
program execution.
11 JTAG_CLOCK JCK Displays or sets a JTAG clock (TCK) frequency.
12 REFRESH RF Updates the HDI memory information to the latest
contents.
13 RESET RE Resets the H8S/xxxx.
14 STATUS STS Displays emulator status information.
15 STEP_INTERRUPT SI Sets or displays the enable or disable status of
interrupts during step execution.
16 TRACE_DISPLAY TD Displays acquired trace information.
Note: Support for these commands varies with the product. For the specifications of each
product, refer to the on-line help.