Ricoh Network Data Protection Unit Type C - Manual (Page 96)

Configuration
96
IEEE 802.11b (Wireless LAN) Configuration
Configure the printer to use IEEE 802.11b (Wireless LAN). The following table
shows the control panel settings and their default values. These items appear in
the [Host Interface] menu.
❒ To use IEEE 802.11b (Wireless LAN), select [IEEE 802.11b] for [LAN Type] in
[Network Setup] in the [Host Interface] menu, and then set [IP Address], [Subnet
Mask], [Gateway Address], [DHCP], [Frame Type (NW)] and [Active Protocol] under
[Network Setup]. For details about setting items under “Configuring the Printer
for the Network”, see Software Guide.
❒ The 802.11b interface unit cannot be used simultaneously with a standard
ethernet interface.
❒ In the [SSID] menu, if blank is specified in 802.11 Ad hoc mode or Ad hoc
mode, “ASSID” appears.
A
Press the {Menu} key.
The [Menu] screen appears.
Setting Name Default Value
Comm. Mode 802.11 Ad hoc
Channel • Inch version
(1-11) 11
• Metric version
(1-13) 13
Trans. Speed Auto
SSID blank (ASSID)
WEP Setting Not Active