Ricoh Network Data Protection Unit Type C - Manual (Page 45)

Installing Options
45
Option Installation Flow Chart
We recommend you install multiple options in the following order:
A
Attach the paper feed unit (Paper Feed Unit Type 3000).
Attach the paper feed unit to the bottom of the printer.
You can attach up to two paper feed unit. Up to 1690 sheets of paper can be
loaded.
B
Install the duplex unit (AD440) to the back of the front cover.
C
Install the SDRAM module (Memory Unit Type D 128MB, Memory Unit
Type E 256MB).
Install the module to the SDRAM module slot on the controller board.
There are two types of memory unit: 128 MB and 256 MB.
D
Install the printer hard disk (Printer Hard Disk Type 3000).
Install the printer hard disk to the controller board.
E
Install the user account enhance unit (User Account Enhance Unit Type
E).
Install the module to the user account enhance unit slot of the controller
board.
F
Install the IEEE 1394 interface board, IEEE 1284 interface board, IEEE
802.11b interface unit or Bluetooth interface unit.
Install the IEEE 1394 interface board, IEEE 1284 interface board, IEEE
802.11b interface unit or Bluetooth interface unit on the controller board.
The IEEE 1394 interface board and standard Ethernet interface cannot be
used at the same time.
Up to two of the following can be installed:
• IEEE 1394 Interface Board Type B
• IEEE 1284 Interface Board Type A
• IEEE 802.11b Interface Unit Type H
• Bluetooth Interface Unit Type 3245
G
Install the network data protection unit (Network Data Protection Unit
Type C).
Insert the network data protection unit into the SD card slot on the controller
board.