Ricoh Network Data Protection Unit Type C - Manual (Page 58)

Installing Options
58
E
Adjust the notch of the Memory Unit to the slot, and then insert vertical-
ly.
F
Press the Memory Unit down until it clicks into place.
G
When replacing the default SDRAM module, press down the levers on
both sides ( ) to remove the default module ( ).
Install a new SDRAM module.
❒ To increase memory capacity to the maximum of 512 MB, remove the de-
fault SDRAM module, and then install two 256 MB SDRAM modules.
H
When installing other options on the controller board, do not close the
controller board, but go to the steps for installing the option.