Ricoh Network Data Protection Unit Type C - Manual (Page 59)

Installing Options
59
I
Align the controller board with the top and bottom rails, and then push
it carefully in until it stops.
J
Hold the machine with one hand, and then push the lower handle of the
controller board with the palm of your other hand, until it stops.
❒ Malfunctions can occur if the controller board is not set properly.
K
Secure the controller board to the printer using the two screws removed
in step
B .
❒ After finishing installation, check the memory unit is installed properly: print
the configuration page from the “List/Test Print” menu. If it is installed prop-
erly, you will see the memory capacity for “Total Memory”.