Ricoh Network Data Protection Unit Type C - Manual (Page 65)

Installing Options
65
❒ After finishing installation, check the printer hard disk is installed properly:
print the configuration page from the “List/Test Print” menu. If it is installed
properly, you will see “Printer Hard Disk Drive” for “Controller Option”.
❒ If the printer hard disk is not installed properly, reinstall it from the start of
the procedure. If you cannot install it properly even after attempting rein-
stallation, contact your sales or service representative.
For details about printing the configuration page, see p.40 “Test Printing” .
Formatting the Printer Hard Disk
If it becomes necessary to format the printer hard disk after initial setup, execute
[HD Format] in the [Maintenance] menu.
❒ Formatting the printer hard disk will delete all data.
A
Press the {Menu} key.
The [Menu] screen appears.
B
Press the {U} or {T} key to display [Maintenance], and then press the {#
Enter} key.
The menu for selecting [Maintenance] items appears.
C
Press the {U} or {T} key to display [HD Format], and then press the {# En-
ter} key.
A check message appears.
Menu:
Maintenance