Ricoh Network Data Protection Unit Type C - Manual (Page 94)

Configuration
94
N
Press the {U} or {T} key to display [DHCP], and then press the {# Enter}
key.
O
Press the {U} or {T} key to display [On], and then press the {# Enter} key.
❒ “p ” shows the current setting.
❒ After about two seconds, the display returns to the network setup menu.
P
If you use NetWare, select the frame type for NetWare.
Select one of the items below if necessary.
• Auto Select (Default)
• Ethernet II
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
❒ Usually, use the default setting (“Auto Select”). When you first select [Auto
Select], the frame type detected by the printer is adopted. If your network
can use more than two frame types, the printer may fail to select the correct
frame type if [Auto Select] is selected. In this case, select the appropriate
frame type.
Q
Press the {U} or {T} key to display [Frame Type (NW)], and then press the
{# Enter} key.
The current setting appears on the display.
R
Press the {U} or {T} key to display the frame type you want to use, and
then press the {# Enter} key.
Network Setup:
DHCP
DHCP:
*On
Network Setup:
Frame Type (NW)
Frame Type (NW):
*Auto Select