Ricoh Network Data Protection Unit Type C - Manual (Page 81)

Installing Options
81
H
Holding the antenna cap with the two cut off corners toward the printer
front cover, fit the cap over the card.
❒ After finishing installation, check the Bluetooth interface unit is installed
properly: print the configuration page from the “List/Test Print” menu. If it is
installed properly, you will see “Bluetooth” for “Controller Option”.
❒ If the Bluetooth interface unit is not installed properly, reinstall it from the
start of the procedure. If you cannot install it properly even after attempting
reinstallation, contact your sales or service representative.
For details about Bluetooth interface unit, see the manual that comes with
the Bluetooth interface board.
For details about printing the configuration page, see p.40 “Test Printing” .