Ricoh Network Data Protection Unit Type C - Manual (Page 22)

Setting Up
22
Unpacking
To protect it from shock and vibration during transit, this printer comes packaged
in cushioning foam and secured with tape. Remove these protective materials
after bringing the machine to where it will be installed.
❒ Be sure to remove all four strips of tape from the photo conductor unit to avoid
malfunction.
❒ Removed tape is dirty. Be careful not to let it touch your hands or clothes.
A
Remove the plastic bag.
B
Position the printer where it is to be used. Lifting the printer requires at
least two people.
Lift using the inset grips on both sides of the printer.
❒ Leave the tape holding the paper feed tray and cover in place while moving
the printer.
❒ Lower the machine slowly and carefully to prevent trapping your hands.
• When lifting the machine, use the inset grips on both sides. The printer
could break or cause an injury if dropped.
• Place no objects on the right cover.