3 changing the osd language, 4 adjusting the picture orientation, Changing the osd language – Runco Reflection User Manual
Page 38: Adjusting the picture orientation
28
Runco CL-410 and CL-420 Owner’s Operating Manual
4.3
Changing the OSD
Language
The CL-410/CL-420 OSD language is initially set to English, but can also display the
menus in French, Italian, German or Spanish. To change the OSD language:
1.
Press MENU.
2.
Select Installation from the Main Menu.
3.
Select Language from the Installation Menu.
4.
Press
or
to select the desired language. The change takes effect immediately.
4.4
Adjusting the Picture
Orientation
By default, the CL-410/CL-420 is configured for a “floor/front” installation, in which the
projector is installed upright and in front of the screen. If it is installed behind the screen
and/or mounted on a ceiling, you must change the picture orientation. To do this:
1.
Press MENU.
2.
Select Installation from the Main Menu.
3.
Select Picture Configuration from the Installation Menu.
4.
Choose Floor Rear, Ceiling Front or Ceiling Rear, to match the installation method.