Runco SIGNATURE CINEMA SC-50D - Manual (Page 23)

Controls and Functions
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual 7
PRE
L
IMINAR
Y
1. RS232 IN
Connect the RS-232 output from the DHD Controller here, using the provided
RJ11-to-DB9 adapter and communication cable.
2. PWR LED
Lights green to indicate that power is applied and the module is initialized. During
normal operation, always on.
3. 1 - Dual-Link DVI-I Input (Slot 2)
HDCP-compliant digital video input. Connect the HDMI output from the DHD
Controller to this input (see Figure 2-4).
4. Analog LED
Lights briefly when the projector is powered up (self-test). During normal operation,
always off.
5. Digital LED
Lights green to indicate that a valid digital signal from the DHD Controller is present.
6. MAIN POWER SWITCH
Disconnects or applies power to the SC-50d/SC-60d.
7. POWER INPUT (100 to 240 VAC)
Connect the projector to power here.
Use ONLY the AC power cord shipped with the
SC-50d/SC-60d for this purpose (the one with the ferrite
sleeve). Doing otherwise creates a fire hazard risk.
WARNING