Pre l iminar y – Runco SC-1 User Manual
Page 108
Maintenance and Troubleshooting
96
Runco SC-1 Owner’s Operating Manual
PRE
L
IMINAR
Y
Panel Driver and Formatter
80
Unrecognized IRAM (panel driver).
81
Unable to program device on IRAM.
82
TI flash download failure.
83
TI flash download fault; partial success.
84
TI flash download fault; partial success.
85
TI-I2C write failure.
87
Consecutive faults from modular Formatters.
90
Red modular Formatter communication failure.
91
Green modular Formatter communication failure.
92
Blue modular Formatter communication failure.
93
Modular formatter architecture error.
94
Modular formatter/DMD mismatch.
95
Modular formatter sequence mismatch.
96
EFIB not responding to I2C messages.
Miscellaneous
A0
Unable to program the optional interface module.
A1
Unable to power the optional interface module.
A2
Unable to program the Dual Slot Backplane Module (DSBP).
A3
Unable to program the optional Post Processing Module (Warp module).
Table 5-2. SC-1 Error Codes (continued)
Code
Description
Note: To clear a system error, press the EXIT key (on the SC-1 control panel) twice. If necessary,
reset the projector by powering it off, allowing it to cool and powering it on again. Contact your
Runco dealer or Runco technical support if the error persists.