Figure 5-2 . installing a new lamp, 2. installing a new lamp, Figure 5-2 – Runco SC-1 User Manual

Page 101: Pre l iminar y

Runco SC-1 Owner’s Operating Manual

PRE

IMINAR

Figure 5-2. Installing A New Lamp

12. Rest the anode (+) end of the lamp on the lamp cradle as shown in Figure 5-2. Then,

slip the positive lamp connector over the bulb end.

13. Tighten the set screws in both negative and positive lamp connectors; see Figure 5-3.

If you accidentally touch the quartz body of the lamp with your bare hands, clean the
surface as described in Maintenance and Cleaning on page 85.

Figure 5-3. Securing Lamp Anode (+) and Cathode (-) Connectors