Radio Shack TAD-1010 - Manual (Page 20)

20
MEMORY OPERATION
You can store up to 10 phone numbers
in the TAD-1010’s memory, then quickly
dial them.
Note: Each phone number can be up to
16 digits long.
Storing a Number in Memory
1. Press OFF on the handset.
2. Press PROG . The TALK indicator
flashes.
3. Press the number ( 0 – 9 ) of the mem-
ory location where you want to store
the phone number.
Note: If you do not complete Steps
2 and 3 within 30 seconds, the tele-
phone exits this procedure. Start
again from Step 2.
4. Using the handset, dial the number
you want to store.
Notes:
• To store the last number dialed,
press REDIAL .
• For security purposes, we recom-
mend that you do not store pri-
vate numbers, such as personal
identification numbers or pass-
words.
• If you have pulse service and
want to use tone dialing, press
TONE at the appropriate place
in the number sequence.
• To store one or more pauses in
the memory number, see “Stor-
ing a Pause in Memory” on
Page 21.
• Each pause or TONE entry
counts as one memory digit.
5. Press MEM (memory) to store the
number in memory. The phone
rings once.
Note: If you hear a long buzzing
tone, the number is not stored.
Repeat the procedure.
Repeat this procedure for each number
you want to store.
Notes:
• To change or replace a stored
number, simply enter a new num-
ber in its place.
• To erase a number from memory,
repeat this procedure, but skip
Step 4.
TALK CH OFF
PRIVACY / LOW BATT
1
4
7
2
5
8
0
3
6
9
#
GHI
PRS
TONE
ABC
JKL
TUV
OPER
DEF
MNO
WXY
HOLD FLASH PRIVACY
MEM REDIAL PROG
43-771.fm Page 20 Friday, August 13, 1999 2:59 PM