Radio Shack TAD-1010 - Manual (Page 15)

15
• About once a month, fully dis-
charge the battery pack. Otherwise,
it will lose its ability to fully
recharge, and you might have to
recharge and replace it more often.
To fully discharge the battery pack,
keep the handset off the cradle until
PRIVACY/LOW BATT turns on.
Then return the handset to the base
and fully recharge the battery pack.
• Some deeply discharged batteries
take longer to charge. If overnight
charging is not sufficient, try charg-
ing for up to 48 hours.
SETTING THE PULSE/
TONE SWITCH
Set PULSE/TONE for the type of service
you have. If you are not sure which type
you have, do this test.
1. Set PULSE/TONE on the side of the
base to TONE .
2. Press TALK on the handset and lis-
ten for a dial tone.
3. Press any number other than 0 .
Note: If you must dial an access
code (9, for example) to connect to
an outside line, do not enter the
access code either.
If the dial tone stops, you have
touch tone service. Leave
PULSE/
TONE set to TONE .
If the tone continues, you have
pulse service. Set
PULSE/TONE to
PULSE .
4. To hang up, either place the hand-
set on the cradle or press OFF on
the handset.
SETTING THE
TELEPHONE RINGER
Follow these steps to select the tele-
phone ringer sound. You can choose
from four different rings.
1. Press ON/OFF to turn the base off.
TONE PULSE
REPEAT STOP PLAY SKIP
ON/OFF
MEMO
ANNC.
MEMORY
SETUP
VOLUME
MAIL BOX MULTI FUNCTION DISPLAY
ERASE
MULTI-USER
DIGITAL ANSWERING SYSTEM
43-771.fm Page 15 Friday, August 13, 1999 2:59 PM