Radio Shack TAD-1010 - Manual (Page 11)

11
7. For the best reception, adjust the
base’s antenna so it stands straight
up.
Note: If you want to remove the supplied
bracket after attaching it, simply press in
the tab on each side of the bracket and
lift the bracket away from the base.
Mounting Directly on the Wall
Using a drill (not supplied) and the sup-
plied screws and spacers, you can eas-
ily mount your TAD-1010 directly on the
wall.
1. At the desired mounting location,
drill two holes 3 15 /
16
inches apart,
one above the other.
2. Place a spacer over each screw,
then thread a screw into each wall
hole until the screw’s head extends
about
1 /
4
inch from the wall.
3. Plug one end of the supplied 7-foot
modular cord into the TO TEL. LINE
jack.
T ONE
PULSE
3 15 /
16
”
TO TEL. LINE
43-771.fm Page 11 Friday, August 13, 1999 2:59 PM