Radio Shack PRO-89 - Manual (Page 34)

34
MONITORING A STORED CHANNEL
You can continuously monitor a specific channel without scan-
ning. This is useful if you hear an emergency transmission on a
channel and do not want to miss any details — even though
there might be periods of silence — or if you simply want to
monitor that channel.
Follow these steps to manually select a channel.
1. Press MAN .
2. Enter the channel number (1–200).
3. Press MAN again.
CLEARING A STORED CHANNEL
If you no longer want a frequency stored in a channel (and you
do not want to replace that frequency with a different one), fol-
low these steps to clear the stored frequency.
1. Press MAN to stop searching or scanning.
2. To select the desired channel number, use the number
keys to enter that channel number (1–200).
3. Press PGM . PGM appears.
4. Press 0 then ENT . The frequency number changes to
000.0000 to indicate the channel is cleared.
5. To clear another channel, use the number keys to enter
that channel number (1–200), then press PGM again. Or
repeatedly press PGM until the desired channel number
appears. Then repeat Step 4.
CLEARING ALL STORED CHANNELS
1. Press PGM . PGM appears.
2. While holding down MON/CL , press 0 . ALL Ch0000
appears.
3. Press ENT . The scanner clears all channels. Or, if you do
not want to clear all channels, press MON/CL .