Radio Shack PRO-89 - Manual (Page 29)

29
Or, to store the displayed frequency in a channel you
select, press
PGM , use the number keys to enter the chan-
nel number you want to use to store the frequency, then
press
PGM again. The channel number flashes.
If a channel number you entered is already programmed
with a frequency, the channel number and the pro-
grammed frequency appear for about 2 seconds. Then the
channel number flashes and the new frequency appears.
Press ENT to program the new frequency or press CL/MON
to cancel. If you press ENT , the channel and frequency
flash twice, and the scanner stores the displayed fre-
quency. The scanner then continues to search for frequen-
cies.
Notes:
• If there is no empty channel, Ch-FULL appears after
you press PGM . To store more frequencies, you must
clear some channels. See “Clearing a Stored Channel”
on Page 34. To continue searching after
Ch-FULL
appears, hold down ▲ or ▼ . To remain on the frequency
after Ch-FULL appears, press MON/CL . Ch-FULL
disappears.
• If you entered a frequency that is already stored in
another channel, -dUPL- (duplicate) and the lowest-
numbered channel containing the duplicate frequency
flash for about 3 seconds. If you want to store the fre-
quency anyway, press
ENT again. If you do not want to
store the frequency, press MON/CL . The scanner contin-
ues to search. You can then delete the frequency later.
See “Clearing a Stored Channel” on Page 34.
5. To store the displayed frequency in a monitor memory,
press MON/CL . The monitor memory number, , and the
frequency flash twice.
6. To search for another active frequency in the selected
band, hold down ▲ or ▼ for about 1 second. To select a
different band and search for another active frequency,
repeat Steps 2–5.
M